#1
|
||||
|
||||
![]() السلام عليكم ازيكم يا شباب النهادة وانا بسرش على النت وقعت فى موقع روسى جايب مواضيع بالصور لتعديلات للعربية وانا بتفرج لقيت طريقة فك تبلوة الانوس قلت اجبهلكم بالصور مع الشرح الى كان موجود فى المنتدى هنا ودمجتهم مع بعض فى صورة موضوع للى مش عارف يفك او مقلق زى حلاتى المهم انا حنزل كل صورة وحقول الراجل عمل اية. ![]() 2- remove both screws behind the mirror control panel/plastic trim ![]() 3- turn the steering wheel 90 degrees to the right and remove the screw behind the wheel shown in the pic ![]() 4- turn the wheel 180 degree to the left and remove the other screw shown in pic ![]() 5- remove the upper part of the steering column trim by pulling it upwards ![]() 6- remove the two screws in the top of the gauge area ![]() 7- open the cup holder and pop the bottom of the H shaped trim around the cassette by fingers ![]() 8- remove the upper part of the H trim by hand ![]() 9- remove the screws of both the cassette and the plastic trim underneath it ![]() 10- drag the cassette to the outside ![]() 11- remove both lower screws of the A/C control panel ![]() 12- pull the bottom of the A/C panel to the outside then move it downwards ![]() 13- remove both screws at the bottom of the dash ![]() 14- pull the whole dash to the outside, note that you will have to detach the sockets of the hazard light and the clock/rear fog light (if equipped) ![]() 15- clear the steering wheel and remove the dash face out of the way ![]() 16- remove all 4 screws holding the gauge cluster ![]() 17- tilt the cluster face down and remove the 3 sockets in its back ![]() 18- clear the steering wheel and remove the whole cluster ![]() الموضع طلع سهل اوى ان شاء الله منقول للافاده العامه تقبلوا تحياتى التعديل الأخير تم بواسطة AbOnOrA ; 17-08-2012 الساعة 08:16 AM |
#2
|
||||
|
||||
![]() |
#3
|
||||
|
||||
![]() ![]() ![]() ![]() ![]() ![]() |
#4
|
||||
|
||||
![]()
موضوع رائع ---شكراً على المعلومة والأفادة
__________________
|
#5
|
||||
|
||||
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]() |
|
|